The MP15 gives you three easy-to-use operating modes, to cover every sampling protocol and situation.
MicroPurge (MP) Mode
quickly optimizes control settings to reach the desired pump flow rate.
You don't have to worry about calculating pump cycles or refill and
discharge times.
ID Mode
instantly recalls optimized settings previously established for each
well, providing precise, consistent performance from event to event.
User Set (MN) Mode provides manual control of pump operation for extreme depths and other special cases.
Pressing the UP Arrow increases the bladder pump flow in controlled steps,
The DOWN Arrow Key decreases the pump flow rate in controlled steps.
The LEFT/ RIGHT Arrow Key adjusts the Cycles Per Minute (CPM) of your pump.
The
ID Number changes when an UP or DOWN Arrow is pressed. This number can
be used in ID Mode to recall the setting for the next sampling round.
The CYCLE Key Starts and Stops pump cycling.
The MODE Key changes modes from default MP (MicroPurge) to ID Mode to MN (User Set) Mode. This key also allows battery check.
Pressing
the PAUSE Key puts the controller in HOLD Mode, stopping flow. A second
press starts the SAMPLE mode, which starts a continuous discharge
cycle for controlled sample vial filling without interruption. A third
press returns the system to normal cycling.
Backpack
portability makes the MP15 a powerful tool for faster, more efficient
sampling at remote sites. With its alternate air supply fitting, it
also works great at closer wells.
Multi-mode digital control
