Controller/Compressor for Low-Flow Sampling | How It Works
|
The MP50 gives you three easy-to-use operating modes, to cover every sampling protocol and situation. MicroPurge (MP) Mode quickly optimizes control settings to reach the desired pump flow rate. You don't have to worry about calculating pump cycles or refill and discharge times. ID Mode instantly recalls optimized settings previously established for each well, providing precise, consistent performance from event to event. User Set (MN) Mode provides manual control of pump operation for extreme depths and other special cases. |
|
 |
Pressing the UP Arrow increases the bladder pump flow in controlled steps, |
 |
The DOWN Arrow Key decreases the pump flow rate in controlled steps. |
 |
The LEFT/ RIGHT Arrow Key adjusts the Cycles Per Minute (CPM) of your pump. |
 |
The ID Number changes when an UP or DOWN Arrow is pressed. This number can be used in ID Mode to recall the setting for the next sampling round. |
 |
The I/O Key steps through the sequence of On-Start-Off. |
 |
The MODE Key changes modes from default MP (MicroPurge) to ID Mode to MN (User Set) Mode. This key also allows battery check. |
 |
Pressing the PAUSE Key puts the controller in HOLD Mode, stopping flow. A second press delivers push button controlled vial filling. A third press returns the system to normal cycling. |
Can be used with any any bladder pump system, with the use of simple adapters.